DGCA AME Paper 2 Sample Questions

(1) During towing operations

a) Pilot must be in the cockpit to operate brakes

b) A qualified person should be in the cockpit to operate brakes

c) A person should be in the cockpit to look for obstructions

d) Persons should be stationed at the nose and each of the wing-tips

(2) Tail-wheel type aero planes have the greatest tendency to move side-ways during taxing when there is

a) Cross wind

b) Tail wind

c) Head wind

d) None of these

(3) When parking a aircraft after towing, the nose wheel should be left

a) Pointed straight ahead

b) As it was when towing stopped

c) Unlocked

d) All are correct

(4) Before towing a large aircraft

a) Ballast should be put in the cockpit

b) Tow bar should be fitted with a strong bolt

c) Tow bar should be fitted with a shear bolt

d) None of these

(5) The most commonly used driving tool by a mechanic is

a) Ball peen hammer

b) Cross peen hammer

c) Claw hammer

d) Sledge hammer

(6) While towing a large aircraft, personnel required are

a) Two in cockpit

b) As in a) plus one each on wing tips

c) As in b) plus one at the tail

d) As in c) plus one in overall control of operation

(7) I) Body hammers are used for driving stakes into the ground II) Sledge hammers are used for smoothing or stretching the metal

a) Only I) is correct

b) Only ii) is correct

c) Both i) and ii) are correct

d) Neither i) nor ii) is correct

(8) I) Body hammers are used for driving stakes into the ground II) Sledge hammers are used for smoothing or stretching the metal

a) Only I) is correct

b) Only ii) is correct

c) Both i) and ii) are correct

d) Neither i) nor ii) is correct

(9) I) Claw hammers are basically used for driving and pulling out II) The wedge of a cross peen hammer is parallel to the handle

a) Only i) is correct

b) Only ii) is correct

c) Both i) and ii) are correct

d) Neither i) nor ii) is correct

(10) A punch is used to

a) Mark a location

b) Remove a damaged rivet

c) Locate a drill properly

d) AM are correct

(11) i) A pin punch is used to remove the shank of the rivet from the hole after rivet head has been chiselled off ii) Diameter of pin punch should be 1/64 inch smaller than the diameter of the rivet to be removed

a) Only I) is correct

b) Only ii) is correct

c) Both i) and ii) are correct

d) Neither i) nor ii) is correct

(12) i) Location given by a prick punch should always be punched later with a centre punch. ii) Goggles must be used while using any type of punch.

a) Only i) is correct

b) Only ii) is correct

c) Both I) and ii) are correct

d) Neither i) nor ii) is correct

(13) . I) A mushroom head on a punch is better than a crown head since chances of hammer slip are reduced II) A centre punch can be used for a variety of punching applications

a) Only i) is correct

b) Only ii) is correct

c) Both i) and ii) are correct

d) Neither I) nor ii) is correct

(14)Most commonly used slip joint plier has a length of

a) 4 inches

b) 6 inches

c) 10 inches

d) 12 inches

(15) Duckbill plier

a) Is a flat nose plier

d) Neither i) nor ii) is correct

Download Full 100 Sample Questions for AME Exam Paper 2 General Engineering